IP PoE Lighting
ALC0808-IP
Meet the ALC0808-IP
The Netgenium ALC0808-IP is a Pure IP Lighting Controller providing the capability to control up to 8 lighting circuits with a maximum overall load of 16 Amps.
The outputs of the ALC0808-IP(P) are presented on Wieland 6-pole GST sockets providing Live, Neutral & Protective Earth. Two of the outputs have an additional maintained Live.
The ALC0808-IP(W) offers the same functionality as above with a wireable housing . Access to the housing is via 20mm ‘knockout’ conduit entries.
See below for the headline features of the ALC0808-IP:
Native IP Device
Connected to your IP network. Simple to install and easily configured with a web browser.
Onboard I/O
Each unit supports eight analogue and eight digital inputs presented on 4 way Wieland type.
Power over Ethernet
Although the unit requires a mains input, it is possible to use PoE as a redundant power supply for the logic board providing the ability to report mains failure.
Software Control
Remote control via web address and Netgeniums policy server or NGx software.
Tech Specs
Model No
ALC0808-IP
Connectivity
1 No. 10/100 Base TX Ethernet RJ45
Mains Input
230VAC input +/- 10%; 50Hz 2 No. Wieland GST18-3 connectors (In & Loop Out)
Outputs
Switched Load – 3680VA (per output – 8No); any type of load
Maintained Load – 3680VA (per output – 2No); any type of load
Maximum Total Load – Depends upon fusing of primary main circuit:
– 16A (total) for fused circuits
– 20A (total) for circuits protected with MCB Type B or C DSI
DSI – 12VDC (250mA max) 1200 baud independent PSU
Connection – 6-Pole Wieland socket (2 x GST 18-3); plugs supplied with luminaires
Inputs
Digital – Closed or Opened contact (closed to logic 0V). Unit can sense open or close state change
Analogue – 0-12VDC input
Power Out – 12VDC (250mA max)
Connection – 4-Pole Wiedmuller type stackable header (2×16 way on unit); Plugs supplied with sensors (1-0v, 2-DG_IN, 3-AN_IN, 4-12VDC)
Sensors:
Digital – PIR, Switch (latching or retractive), any ‘no-volt’ contracts between 0V & DG_IN
Analogue – 0-12VDC range, recommended Netgenium Sensors (Ambient Light, Temperature, Humidity), must use units 12VDC power
Indicators & Diagnostics
Outputs:
– 8 No. Two-colour LED (for Dim & Full On)
– 2 No. Red LED for Maintained Outputs
Local Diagnostics – Touch sensitive keys on unit to switch outputs On, Off & Dim
Housing
Material – 1.2mm mild steel powder coated, fully earthed
Mounting – Via 2 No. Screw-on brackets, providing 4 No. slot holes (fixings supplied)
Weight – 1500gr
Safety
Outputs
Housing – Protection to IP20
Insulation – Sensors – Double insulation (5.4kV) towards mains regulation – basic insulation (2kV) towards mains Ballasts Connected regulating ballasts and dimmers must have at least basic insulation
Interested?
IP PoE Lighting Data Sheets Available to Buy
Contact our sales team if you’re interested in our products or see where you can purchase them. Click the link above to download the information in a PDF datasheet. You can also print this page or share with somebody: